How to Prevent Frozen Pipes This Winter: 9 Steps That Actually Work
A burst pipe is one of the most expensive accidents that can happen to a home in winter. When water freezes inside a pipe, it expands, pressure builds, and the pipe can split — then, when it thaws, water pours into your walls, floors, and ceilings. The good news: frozen pipes are almost always preventable, and most of the steps below cost little or nothing.
Pipes are most at risk when temperatures fall to about 20°F or below, especially pipes in unheated spaces — basements, crawl spaces, attics, garages, and exterior walls. Here is how to protect them, step by step.
1. Insulate Every Exposed Pipe You Can Reach
Foam pipe insulation sleeves are the cheapest protection you can buy — typically just a few dollars for a 6-foot length at any hardware store. They slip over the pipe and fasten in seconds. Cover pipes in the basement, crawl space, attic, and garage, and do not forget the pipes under kitchen and bathroom sinks on outside walls. Pay special attention to elbows and joints, where cold gets in first.
2. Seal Cracks and Openings Near Pipes
Walk around your basement and exterior walls and look for gaps where pipes, cables, or vents pass through. A blast of cold air through one small hole can freeze the pipe next to it. Seal gaps with caulk or spray foam — a quick job that also lowers your heating bill.
3. Disconnect Garden Hoses and Shut Off Outdoor Faucets
Before the first hard freeze: disconnect and drain every garden hose, close the indoor shut-off valve for each outdoor faucet, then open the outside faucet to let trapped water drain out. A hose left connected traps water in the pipe — a classic cause of a burst pipe inside the wall.
4. Keep the Heat On — At Least 55°F
If you travel in winter, do not turn the heating off. Keep the thermostat at 55°F or higher while you are away. The fuel you use is a fraction of what water damage costs. (Our guide to the best winter thermostat settings shows how to balance savings and safety.)
5. Open Cabinet Doors Under Sinks
On very cold nights, open the cabinet doors under kitchen and bathroom sinks that sit on exterior walls. This lets warm room air circulate around the pipes. If you have small children or pets, move cleaning products out of reach first.

6. Let Faucets Drip on the Coldest Nights
When the forecast drops well below freezing, let the faucet served by exposed pipes drip slowly — about the thickness of a pencil lead, or a steady drip every few seconds. Moving water is much harder to freeze, and an open faucet also relieves pressure if ice does start to form. Choose the faucet furthest from where water enters your home.
7. Add Heat Tape to Problem Pipes
For a pipe that freezes every year, electric heat tape (heat cable) is the targeted fix. It wraps along the pipe, plugs in, and keeps the pipe just above freezing. Follow the manufacturer’s instructions exactly, and never overlap the tape on itself.
8. Keep the Garage Door Closed
Water supply lines often run through the garage. On cold days, keep the garage door shut as much as possible to hold in what warmth there is — it is a simple habit that protects those pipes.
9. Know Where Your Main Water Shut-Off Valve Is
This step does not prevent a freeze — it prevents a disaster. Find your main shut-off valve now (usually near the water meter or where the main line enters the house), make sure it turns, and show everyone in the home where it is. If a pipe ever bursts, shutting this valve in the first minute saves thousands of dollars in damage.
For the rest of your cold-weather prep — windows, doors, insulation, and the furnace — see our winter-ready home guide.
What to Do If a Pipe Freezes Anyway
- Turn on the faucet. If only a trickle comes out, the pipe is likely frozen. Leave the faucet open — as the ice melts, water needs somewhere to go.
- Apply gentle heat to the frozen section with a hair dryer, a heating pad, or towels soaked in hot water. Start near the faucet and work back toward the coldest section.
- Never use an open flame — no blowtorches, kerosene heaters, or charcoal. It is a fire risk and can damage the pipe.
- If a pipe has burst, shut off the main water valve immediately, then call a licensed plumber.
- If you cannot find the freeze, or the pipe is inside a wall, call a plumber before it becomes a burst.
Frequently Asked Questions
At what temperature do pipes freeze?
Pipes become vulnerable when temperatures drop to around 20°F or below, especially in unheated areas or during wind chill that cools exterior walls. Well-insulated pipes in heated spaces can handle lower temperatures, which is why insulation matters.
Should I let all faucets drip to prevent freezing?
No — only the faucets served by pipes in cold or exposed areas, such as sinks on exterior walls. A slow drip is enough; you do not need a running stream.
How much does it cost to insulate pipes?
Foam sleeves typically cost a few dollars per 6-foot length, so insulating the exposed pipes in an average basement usually costs well under $50 in materials — far less than repairing one burst pipe.
Bottom line: insulate what you can reach, seal the drafts, drip the at-risk faucets on the coldest nights, and know your shut-off valve. An afternoon of prevention beats a winter of repairs.
